arduino BME_280_I2C

arduino BME_280_I2C

/*
BME280 I2C Test.ino

This code shows how to record data from the BME280 environmental sensor
using I2C interface. This file is an example file, part of the Arduino
BME280 library.

GNU General Public License

Written: Dec 30 2015.
Last Updated: Oct 07 2017.

Connecting the BME280 Sensor:
Sensor              ->  Board
-----------------------------
Vin (Voltage In)    ->  3.3V
Gnd (Ground)        ->  Gnd
SDA (Serial Data)   ->  A4 on Uno/Pro-Mini, 20 on Mega2560/Due, 2 Leonardo/Pro-Micro
SCK (Serial Clock)  ->  A5 on Uno/Pro-Mini, 21 on Mega2560/Due, 3 Leonardo/Pro-Micro

 */

#include <BME280I2C.h>
#include <Wire.h>

#define SDA_PIN 4
#define SCL_PIN 5

#define SERIAL_BAUD 115200

BME280I2C bme;    // Default : forced mode, standby time = 1000 ms
                  // Oversampling = pressure ×1, temperature ×1, humidity ×1, filter off,

//////////////////////////////////////////////////////////////////
void setup()
{
  Serial.begin(SERIAL_BAUD);

  while(!Serial) {} // Wait

  // 指定 SDA 和 SCL 引脚
  Wire.begin(SDA_PIN, SCL_PIN);

  while(!bme.begin())
  {
    Serial.println("Could not find BME280 sensor!");
    delay(1000);
  }

  switch(bme.chipModel())
  {
     case BME280::ChipModel_BME280:
       Serial.println("Found BME280 sensor! Success.");
       break;
     case BME280::ChipModel_BMP280:
       Serial.println("Found BMP280 sensor! No Humidity available.");
       break;
     default:
       Serial.println("Found UNKNOWN sensor! Error!");
  }
}

//////////////////////////////////////////////////////////////////
void loop()
{
   printBME280Data(&Serial);
   delay(500);
}

//////////////////////////////////////////////////////////////////
void printBME280Data
(
   Stream* client
)
{
   float temp(NAN), hum(NAN), pres(NAN);

   BME280::TempUnit tempUnit(BME280::TempUnit_Celsius);
   BME280::PresUnit presUnit(BME280::PresUnit_Pa);

   bme.read(pres, temp, hum, tempUnit, presUnit);

   client->print("Temp: ");
   client->print(temp);
   client->print("°"+ String(tempUnit == BME280::TempUnit_Celsius ? 'C' :'F'));
   client->print("\t\tHumidity: ");
   client->print(hum);
   client->print("% RH");
   client->print("\t\tPressure: ");
   client->print(pres);
   client->println("Pa");

   delay(1000);
}